New Posts
recent

Bangladesh Rural Electrification Board (REB) Assistant Engineer (2014) Questions with Answer (1-20)


Bangladesh Rural Electrification Board (REB)
Post : Assistant Engineer (Electrical)
Full Marks : 80  Time: 1 Hr
Set-Ka  Year: 2014

1. Reciprocity theorem is applicable for
a.     Unilateral network                   b) bilateral network
b.     ideal network                           d) None of these

2 . A JFET is also called
a.     Unipolar transistor                   b) Bipolar transistor
b.     Unijunction transistor              d) none of the above

3.Form factor of sinusoidal alternating current is
a)1.11%            b)1.11A          c)1.11             d) b and c

4. Relation between resonant power P0 and off- resonant power P is:
a)     P0=P             b) P0>P           c) P0<P           d) none

5. In a parallel resonance ac circuit following points to be
remembered
a)     The admittance equals conductance
b)    both a and c
c)     The power factor of the circuit is unity
d)    None of the above

6. A network which attenuates a single band frequencies and
 allows those on either Side to Pass through is called:
a)     Low-pass filter                        b) High-pass lter
       c) Bandstop lter                          d) Bandpass lter


7. The frequency corresponding to half-power point on the reponse
curve of a filter is known as -
a) Cutoff                             b) Upper
c) Lower                             d) Roll-off

8. If D is the electric flux density,hen the value if electric intensity of a
medium is -
a) D / €0            b) D / €0                 c) €0 / D       d) 0D      

 9. The stabilization of operating point in Potential divider methods is provided by
a)     RE consideration                  b) RC consideration
b)    Vcc consideration.               d) None of the these

10. The stabilization of operating point in Potential divider methods is provided by
                  a) CMMR of the op amp                b) Gain-bandwidth product 
c) supply voltage                            d) Tolerance of the resistors

11. Emitter follower is used for:
b)    a) Current gain           b) Impedance matching
c)     Voltage gain               d) None of these

12. An oscillator differs from an amplifier because it :
   a) Has more gain                     b)  Requires no input signal
   c) Requires no dc supply         d) Always has the same input

13. The dimensions of L/CR are that of
a) Farad   b) Henry   c) Ohm    d) None

14. In the breakdown region, a zener diode behaves like a
a) Constant current source                      b) Constant resistance
c) Forward biased                                   d) Constant voltage source

15. The maximum efficiency of a half-wave diode rectifier is :
a) 50%         b) 25%            c) 40.6%       d) 81.2%

16. The collector of a transistor is :
                  a) Heavily doped                                       b) Moderately doped
c) Lightly doped                                        d) None of these

17. Transsistor biasing is done to keep:
a)     Proper ac current in the circuit
b)    The base current small in the circuit
c)     Proper dc current in the circuit
d)    Collector current small in the circuit

18. According to Faraday’s Laws of Electromagnetic Induct,an emf is
induced in a conductor whenever it
a)     Lies in a magnetic field
b)    Cuts magnetic flux
c)     Move parallel to the direction of the magnetic field
d)    Lies perpendicular to the magnetic flux

19. The phase difference between the output and input voltage of a CE amplifier is:
a) Class A operation                b) Class C operation
c) Class B operation                d) Class AB operation

20. If a three-stage amplifier has individual stage gains of 10 dB and 15 dB,then the total gain is:
a)     a) 750 dB                     b) 30 dB                 c) 24 dB                       d) 7.5 dB
Zim

Zim

No comments:

Post a Comment

Powered by Blogger.